Maintenance; Cleaning The Machine; Troubleshooting - Makita UB001C Betriebsanleitung

NOTE: When unlocking the buckle, press the claws
of the buckle on both sides. When locking the buckle,
insert the claws until they are locked.
► Fig.34: 1. Claw
Using the gutter nozzle set
CAUTION:
When using the gutter nozzle set,
do not use the machine in the Boost mode. You
may loose balance and it may cause an accident since
the air volume becomes larger in the Boost mode.
CAUTION:
When using the gutter nozzle set,
do not hold the blower with single hand but with
both hands.
► Fig.35
CAUTION:
Do not use the gutter nozzle set
near electric wires.
► Fig.36
CAUTION:
Do not use the gutter nozzle set on
windy day.
► Fig.37
CAUTION:
When using the gutter nozzle set,
keep other people or animal more than 15 m (50 ft)
away from the blower.
► Fig.38
Hold the blower upright by grabbing the handle of the
blower. Place the outlet of the blower on the gutter and
then turn on the blower.
► Fig.39

TROUBLESHOOTING

Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the man-
ual, do not attempt to dismantle the machine. Instead, ask Makita Authorized Service Centers, always using Makita
replacement parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
The machine does not reach the
maximum speed.
Abnormal vibration:
stop the machine immediately!
Motor cannot stop:
Remove the battery immediately!
Probable cause (malfunction)
Battery is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work correctly. Ask your local authorized service center for repair.
The drive system does not work
correctly.
Electric or electronic malfunction.
16 ENGLISH

MAINTENANCE

CAUTION:
Always be sure that the machine is
switched off and the portable power pack is dis-
connected from the machine before attempting to
perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

Cleaning the machine

Clean the machine by wiping off dust with a dry cloth or
one dipped in soapy water and wrung out.
► Fig.40
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Remove dust or dirt from the suction inlet at the rear of
the machine.
► Fig.41: 1. Suction inlet
Storage
Before storing the machine, disconnect the portable power
pack from the machine, and perform full maintenance.
Store the machine in a place out of the reach of children
and not exposed to moisture, rain, or direct sunlight.
The hook hole on the bottom of the machine is conve-
nient for hanging the machine from a nail or screw on
the wall.
► Fig.42: 1. Hole
Remedy
Install the battery.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
Stop using the machine to allow it to cool down.
Install the battery as described in this manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Remove the battery and ask your local authorized
service center for repair.