Troubleshooting - Silvercrest RF-1002 Benutzerhandbuch

Step 3: Set up your mouse
Information: If you are using Windows98/ME, follow the on-screen instructions after you
have connected and powered on the devices. Under Windows 2000/XP you must wait until
the device has been detected and installed.
Note: This is a must to follow the steps in order to set up your mouse successfully!
1. Press the "ID" button an the top of the receiver.
2. To power on, press the "ID" button located at the bottom of the mouse
3. Move the mouse freely to make sure the connection is ok. Once the connection between
mouse and receiver has been established successfully, the red LED starts blinking quickly.
Your mouse has been successfully configured.
STEP 4: Powering the Mouse Off
In order to the reduce power consumption, you can power off the mouse. To do so, press
and hold the "ID" button on the bottom of your mouse for about 5 seconds.
Note:
1. The products cannot work on highly glossy surfaces and deep dark colour surfaces, such
as mirror, glass, marble surface. It can work on light colour surfaces, such as desktop,
computer table surfaces and so an.
2. The products will go to sleeping mode when you da not operate the product more than
20 minutes, that can reduce the power consumption. You may press any button of the
mouse to arouse it to working status.
Trouble Shooting
The mouse cursor does not move properly.
1. Change the position of your radio receiver, because it may be too far from the mouse or
a large metal object may be interfering with the receiver radio reception. Try moving the
receiver and/or mouse to improve the reception.
2. The interference may occur from other same products at near distance in office or
home, you may change the ID code (see Step 3) several times in order to get optimal
performance.
"ID"
2