Safety Instructions - Silvercrest RF-1002 Benutzerhandbuch

Welcome
Your mouse uses digital radio technology to communicate with your computer.

Safety instructions

1. Do not allow children to play with electrical devices when not under supervision.
Children may not be able to comprehend the presence of potential risks.
2. The equipment must not be splashed by water. Do not place any recipients containing
liquids (like vases or beverages) onto or next to the device.
3. Do not place any fire (such as candles) onto or next to the device.
Step 1: Install batteries into the mouse
The wireless mouse uses two AAA Ni-MH or alkaline batteries.
1. Open the battery cover at the top of the mouse.
2. Insert the two AAA batteries.
3. Replace the cover after the batteries are installed.
Attention!
Do not expose the battery to heat or fire. Do not attempt to short circuit, disassemble or
recharge the battery. Batteries can explode and cause severe injury.
Put the battery in a place where young children cannot reach it. Accidental swallowing of
the battery can be fatal.
Dispose worn-out batteries not with your domestic waste.
Please contact your local government for disposal practices in your area.
Step 2: Connect the receiver
Information: Turn off your computer before you connect the receiver. If you connect the
USB receiver while the PC is powered on, it could be damaged.
1. Make sure that your computer is turned off.
2. Connect the receiver to the USB port an the computer.
3. Turn on your computer
USB Connector
When the connection is successful, the indicator light shines.
1