Connections; Power Supply - Feig Electronic ID ISC.SPAD102 Installation

®
OBID i-scan

11 Connections

11.1 Power supply

11.1.1 Power supply
Connect the 12..24 VDC/
Table 11-1: Connecting the supply voltage
Terminal
inside VDC
outside
Note:
Reversing the polarity of the supply voltage may destroy the device.
Power supply recommendations :
To take full advantage of the Reader performance, you must use a sufficiently regulated and low-
noise power supply. When using a switching power supply, be sure that its internal switching fre-
quency is less than 300 kHz.
Table 11-2: Recommended power supply:
Feig Article No
1688.002.00
FEIG ELECTRONIC GmbH
supply voltage to socket on the circuit board.
Name
Vcc – supply voltage (+)
Ground – supply voltage (-)
GND
Part No.
ID NET.12V-B
Page 24 of 32
Installation
Description
Power Supply 95 - 265V AC Input Voltage,
(Continental European Plug),
with angular DC Plug 2,5mm*5,5mm
Output: 12 V DC/
ID ISC.SPAD102
Terminal
Description.
; 700mA
M10414-2de-ID-B.doc