Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Central Box 200 Release Notes
Fail-Safe - Disabled
- In case of signal loss event on both Rx1 and Rx2 inputs, the Central Box stops generating impulses to
servos.
Output Period
- Determines how often the control pulses for servos are generated on the Central Box outputs.
- It is possible to adjust the output period from 5-30ms, or Auto period can be selected.
- When using digital servos, it is advisable to use the Auto option; if the analogue servos are used, then it
is recommended to set a fixed period (eg. 20ms).
Pin Config - Servo
- Standard impulse servo output (-100% = 1,00ms, 0% = 1,5ms / +100% = 2,00ms).
Pin Config - Digital
- The output pin is in a stable LOW condition (log. 0) if the deflection of the assigned channel is lower
than the set decision limit, otherwise this pin is in a HIGH condition (log.1).
Pin Config - Input
- Here the pin is configured as an input and its condition (disconnected / connected to the ground) is sent
to the transmitter as other telemetry data from the sensors.
- Only keep the pin disconnected or connected to the common ground of the Central Box.
- Never connect to a different voltage. The pin works exclusively in PullUp mode.
Version 1.11 (November 2013)
User-defined alarm notifications on disconnected receiver or signal loss have been added. You will find
new items "RX1 Alarm" and "RX1 Alarm" in the Alarms menu of the Central Box.
EN – DE - CZ
-2-
Werbung
