Acer HMU.0550.003 Benutzerhandbuch Seite 4

2
Note: Execute this program to match the country you are currently
in for the modem to function properly.
Installing and Testing the Modem
Installing and Configuring the Software
Install the communications software according to the software user's
modem of the same COM port and IRQ line used by the modem. You
may be prompted by the software to configure certain communication
parameters. We suggest the following settings:
Item
Baud rate
Data bits
Parity
Stop bit
Flow control
initialization string
Testing Your Modem
In order to check if the modem is installed properly, make sure that the
COM Port and IRQ settings of the modem match the software. Type AT
on your terminal screen and press ENTER. The modem should respond
by displaying an OK (or 0). If it does not, either the modem may not
have been installed properly or the software has not been properly
configured.
Using Your Modem
The communications software included with your modem provides a
user friendly interface to access the data and fax. The modem may also
perform basic communication functions (such as dialing) via the AT
commands. Please refer to "AT Commands" on page 4 for detailed
Suggested Setting
115200 bps
8
none
1
Xon./Xoff
AT&F