Epson ELPLL07 Bedienungsanleitung Seite 10

Handling and Storing the Lens Unit
Pay close attention to the following contents when handling and storing the lens unit.
vDo not store in locations with high temperatures or high humidity. It may in particular be
damaged or deformed by leaving it for extended periods in locations with unusually high
temperatures such as in direct sunlight or next to a heater.
vDo not disassemble or remodel.
vUse and store in places that do not exceed the projector's operation and storage
temperature.
vDo not get it wet.
vDo not drop it or subject it to impacts. When putting this product down, make sure you
place it on a flat, stable surface.
vDo not touch the connecting part of the lens unit.
Removing and Attaching the Lens
Unit
When attaching or removing the lens unit to or from the projector, place the projector on a
stable flat surface.
If the projector is mounted on a ceiling, dismount it from the ceiling mount beforehand.
Attaching
The shapes in the illustrations may differ depending on the lens being used, but the method
is the same.
Prepare #2 plus-driver in advance.
Caution
vDo not attach the lens unit when the projector's lens insertion section is facing up. Dust or
dirt could enter the projector.
vTry not to touch the lens section with your hand or fingers. If fingerprints or oils are left on
the surface of the lens, projection quality deteriorates.
vIf the lens shift has been done, set the lens shift to the center before replacing the lens
unit.
10