Epson ELPMB30 Bedienungsanleitung Seite 16

Tighten these temporarily.
Do the same
for the other side.
Secure these.
Do the same
for the other side.
16
C
While supporting the projector, tighten the four screws
temporarily with the ball point hex wrench.
Do not tighten the screws too much at this point.
D
Adjust the angle while lowering the projected image by
turning the adjustment dial
If the projected image is lowered too much, go back to Step 1
and try again.
E
After angle adjustment is complete, tighten the four screws
firmly using the ball point hex wrench.
.