Mounting Projector Plate On The Projector - Epson ELPMB30 Bedienungsanleitung

Mounting Projector Plate on the Projector

Warning
v Be sure to tighten the screws securely.
After tightening the screws, try re-tightening them once again and make sure that all of them are securely tightened.
v Applying threadlocker, lubricant, oil or other substance to the points at which the projector is fixed to this
product may make the case crack and the projector may fall, and which may cause injury or an accident. Do
not use any sort of adhesive, lubricant, or oil when installing or adjusting this product.
Necessary items for the following procedure
Y Projector plate
Procedure
Set this part to the rear of the projector.
Y M4x12 screws
(mm; pan, w/ washer)
A
*
Set the projector plate on the projector as shown in the
figure, and align the screw holes on the plate with the
projector's screw holes for the ceiling mount.
* When installing the projector plate on the EH-R4000/R2000/
Caution
Depending on projectors, the screw holes for the projector plate differ.
For the details, refer to "User's Guide" supplied with the projector.
B
Insert the M4x12 screws into the screw holes and tighten
Secure these.
them with the Phillips screwdriver.
Caution
When securing the projector and the projector plate, be sure to use
the included M4x12 screws.
Prepare a commercially available Phillips screwdriver necessary to
attach the plate.
R1000, the installation direction is the other way around of what
you see in the figure.
11