Precautions On Where To Mount The Projector - Epson ELPMB30 Bedienungsanleitung

v Do not strongly pull or pinch the projector's power cable during installation. Do not modify the power cable or
use any damaged cable.
Doing so may cause fire or electric shock.
If the power cable is damaged (exposed conductor, breaking or the like), contact your dealer or Epson customer service
call center.
v Disconnect the power cable from the projector before cleaning. When cleaning it, do not use a moistened cloth or
solvents such as alcohol, thinner or benzine.
Doing so may cause damage, fire, or electric shock.
Clean the product using a damp, tightly wrung out cloth.
v Under the following conditions, do not use this product, but contact your dealer or Epson customer service call
center.
• If you dropped or broke the product before or during installation
• If the supplied parts is abnormal or do not function normally
Do not install the projector in places where the temperature may rise or fall out of the projector's operating
temperature range.
Doing so may cause damage to the projector.

Precautions on Where to Mount the Projector

Carefully read the warnings in "Safety Instructions / Support and Service Guide" supplied with your projector before starting
the installation to determine a suitable place to install it. In particular, pay attention to the following.
v Avoid installing the projector in a place where the receiver for the remote control may be exposed to direct sunlight or
strong light from fluorescent lamps. If strong light shines onto the receiver, remote control may not operate normally.
v Do not install the projector near the exhaust duct of an air conditioner.
v To limit the effect of external noises, it is recommended that the projector should be installed in a place so that the cables
connected to a computer or other devices can be shorter than 20 meters.
v Determine the mounting position leaving enough space to maintain the projector such as cleaning and replacing the
consumables.
6
Warning
Caution