Child Lock; Open Door Alarm; High Temperature Alarm - Atag KD85178CD Bedienungsanleitung

OPERATING THE APPLIANCE

Child Lock

This function can be used to prevent unintended adjustments of the appliance's settings. All keys
other than the ECO/Child Lock key are disabled.
Switching the Child Lock on or off

Open door alarm

An alarm signal sounds when a door is open for too long. The alarm key flashes in the display.
The lighting will begin to flash after a few minutes.
Stopping the alarm
1. Close the door.
▷ The alarm will stop sounding.
When the door is still open after 10 minutes, the appliance will switch to safe mode.
The LED lighting goes off. Error code E9 will be shown in the display (see the chapter
'Faults').
If you only switch off the alarm by touching any key, the alarm will switch on again after
some time because the door is still open.

High temperature alarm

A signal will sound when the temperature in the appliance is too high. The alarm key and the
set temperature shown in the display will flash. A high temperature can be caused for several
reasons:
• The door has been opened for too long or too frequently.
• The door does not seal properly.
• Too much fresh food has been put in at the same time.
EN 20
1. Touch the ECO/Child Lock key for three seconds.
▷ 'LL' is shown in the display to indicate that the Child Lock is
activated.
2. Touch the ECO/Child Lock key again for three seconds.
The function is disabled.
▷