Vacmaster JOEY Bedienungsanleitung Seite 9

3) Insert the desired plug into the charging power adapter. Align the support rails located on the
charging adapter body with the guide rails on the plug insert (Fig. 7). Slide the plug insert fully
towards the charging adapter body to lock into place until you hear a click (Fig. 8).
NOTE: To remove the plug, press the release latch on the charging adapter and slide the plug
insert off the charging adapter body (Fig. 9).
4) Insert the charging adapter into the charging port located on the side of the charging base and
secure the cord.
5) Insert the vacuum cleaner onto the support rails of the charging base. Ensure all connections
are clean and free of dirt (Fig. 10).
6) Plug the charging adapter into a suitable power supply (Fig. 11).
NOTE: The vacuum cleaner sits in the charging base and is held into position while charging
by the support rails. Ensure you place the vacuum cleaner downwards onto the charging base
and ensure the vacuum is correctly docked. Make sure that there is nothing obstructing the
connections which may prevent charging.
7) While the vacuum cleaner is being charged, the battery charging indicator ( ① ) will flash
continuously until fully charged (Fig. 12).
8) When fully charged, the charging indicator will turn off. Unplug the charging adapter from the
power supply and remove the vacuum cleaner from the charging base.
NOTE: If the battery charging indicator does not illuminate when charging, ensure that:
• The vacuum cleaner is seated properly onto the charging base.
• The charging plug is plugged into the power supply properly.
• The power supply is switched on.
• The charging connector is fully inserted in the charging base.
2. Using Your Vacuum Cleaner
Before vacuuming, check that the brush roll is clear from any obstructions such as hair or sharp
objects to avoid scratching floors, and that the dust bin is empty.
NOTE: Use the low-speed setting for cleaning of hard floors, and low pile rugs. The high-speed
setting should be used for cleaning plush rugs and carpets or when additional cleaning power is
required.
1) To start the vacuum cleaner, slide the power switch to the LOW speed position.
2) To increase the speed and performance of the vacuum cleaner slide the power switch to the
HIGH speed position.
3) To stop the vacuum cleaner, place the power switch in the OFF position.
9
GB
Power/Speed
Switch