T.I.P. SPU 36000 Gebrauchsanweisung Seite 16

1. ATTENTION: Before performing any installation or maintenance tasks,
disconnect the electrical devices immersed in the pond from the power source by
pulling the plug out of the socket outlet. Do not operate the pump if there are
people in the water. Switch off the main fuse of the main domestic power supply,
before unplugging the mains cable, if the connection plug or the main power
outlet are wet. Never transport or suspend the device by the mains cable.
2. Ensure that the voltage specified on the type plate of the device agrees with the
mains voltage.
3. Prior to connecting the device to the mains supply, ensure that the mains cable
and the device are not damaged in any way.
4. The mains cable of the device must form a loop that points downward (DRIP
LOOP) to prevent water from running along the cable and into the socket outlet.
5. The device must have a residual current circuit breaker (RCCB) with a rated
residual current of max. 30 mA connected on the line side. Consult a qualified
electrician.
6. Do not bury the mains cable in the ground; follow the installation instructions
specified in the applicable local regulations. Consult a qualified electrician.
7. Prior to placing the device in service, ensure that the installation has been
properly executed.
8. Do not use or store the device in areas where there is danger of freezing. In
winter the device should be removed, emptied and stored where it is protected
against freezing.
9. Do not let the pump run dry (without water flow).
10. Do not use the device with corrosive liquids.
11. The temperature of the pumped liquid must not exceed 35°C (max.) and must
not under range 2°C
12. ATTENTION! Only use the UVC filter together with the safety transformer
included in the scope of delivery. If there is a defect, the complete UVC unit
must be replaced.
13. ATTENTION: This device emits UVC radiation that can harm eyes and skin. Do
not use the bulb outside of the device
14. ATTENTION: NEVER LOOK DIRECTLY INTO THE UVC TUBE WHEN IT IS
SWITCHED ON
15. ATTENTION: This device consists partially of glass! Handle with care!
16. The max. temperature of the pumped liquid must not exceed 35°C
17. The UV filter is not designed for immersion in water. If the device should
accidentally fall into the water, do not, under any circumstances, attempt to get it
out of the water, until you have pulled the mains plug out of the mains socket
outlet. Also unplug the mains plug if you determine that the exterior of the device
is wet
18. To avoid an overheating of the lamp, please switch of the lamp if there is no
direct water flow.
19. ATTENTION! Temporarily stop the operation of the UVC lamp, while treating the
water or fish inside your pond with additional care products.
14
3