Stop The Machine; Machine Operation (Scrubbing And Drying) - Viper AS1050R Schnellstartanleitung

QUICK START GUIDE
9.
If necessary, press the emergency button (N, Figure 13) for machine
emergency stop.
10.
If necessary, press the front lights button (C, Figure 13) for dark areas or to
warn pedestrians.
11.
If necessary, adjust the seat (K, Figure 13) by turning right the handle on the
right of seat, then slide the seat to proper position.
NOTE
The brush motor, vacuum motor, drive motor and control
circuit are protected by overload protector (P, Figure 13).
When an overload protector trips, do not reset it immedi-
ately without finding out the root cause, and make sure the
motor has cooled before reset.

Stop the machine

12.
Release the accelerator pedal (Q, Figure 13), the machine stops running.
13.
Press One-Start button (G, Figure 13) to stop brushes and vacuum motor. The
brushes and squeegee are lifted from the floor automatically. The vacuum
system will turn off after a few seconds.
14.
Turn the Ignition key to "0".
15.
Make sure the machine cannot move independently.

MACHINE OPERATION (SCRUBBING AND DRYING)

1.
Start the machine according to procedures in previous paragraphs.
2.
Start cleaning by following procedures in section of "Starting the machine".
3.
If necessary, stop the machine to adjust side splashguards according to section "Adjusting the balance of side splashguards".
4.
If necessary, stop the machine to adjust squeegee according to section "Adjusting the balance of squeegee".
NOTE
For correct scrubbing/drying of floors at the sides of the walls. It is suggested to go near the walls
with the right side of the machine (Figure 14) as shown in the figure.
Figure 14
12
ENGLISH
Figure 13