Viper AS1050R Schnellstartanleitung Seite 13

QUICK START GUIDE
Proceed as following:
INSTALLATION:
1. Insert the Ignition key (53, Figure 3) and turn it to "I". Lift the deck.
2. Place brushes (A, Figure 8) or pad-holders (B, Figure 8) under the
deck. Use the brush installation stop (D, Figure 8) to help find the
proper brush/pad holder position.
3. Install the brush/pad-holder by pressing the Brush/pad-holder click
on button (F, Figure 8), the brush/pad-holder will be automatically
installed. The rotation direction is shown (Figure 8). The LED
indicator light will flash.
REMOVAL:
1. Insert the Ignition key (53, Figure 3) and turn it to "I". Ensure the
brush/pad-holder is in the raised (UP) position. Remove the
brush/pad-holder by pressing the brush/pad-holder release button
(E, Figure 8), the brush/pad-holder will be automatically released.
The LED indicator light will be steady on.
ADJUSTING THE BALANCE OF SIDE SPLASHGUARDS
The splashguard height needs to be monitored, and adjusted. While cleaning with the machine,
check the performance of the side splashguards.
A. If the splashguards are too high, the gap between the splashguard (D) and the floor, will
leave water on the floor during turns.
B. If the splashguards are too low, the splashguard (D) will deflect too far, leaving water
during turns, and reducing the life of the splashguard.
C. Proper adjustment is when the splashguards lightly touch the floor from the front to the
rear of the splashguard.
Adjusting procedure as follows:
1. Ensure the deck is in the raised (UP) position.
2. Loosen the top retention nuts (A), and remove the splashguard assembly.
3. Adjust the lower retention nuts (B) up/down.
4. Re-install the splashguard assembly and check the adjustment.
5. Repeat 3. & 4. as required until the splashguard adjustment is correct.
6. Tighten the tope retention nuts (A) to secure the adjustment.
7. Repeat the procedure on the other side splashguard.
ADJUSTING THE BALANCE OF SQUEEGEE
1. Install the squeegee and tighten up the nuts (C, Figure 10), then connect
the vacuum hose (B) to the squeegee.
2. Adjust the squeegee by squeegee adjusting knob (A).
a) If there is a gap between the ground and middle section of rear squeegee
blade (E), adjust the knob (A) in clockwise direction (H) until all sections
of the rear squeegee blade make good contact with the ground, and the
front blade touches the ground slightly.
b) If there is a gap between the ground and both end sections of the rear
blade (D and F), adjust the knob (A) in counterclockwise direction (G)
until all sections of the rear squeegee blade make good contact with the
ground, and the front blade touches the ground slightly.
If necessary, adjust the whole squeegee height by adjust the caster wheel (K)
height.
10
ENGLISH
Figure 8
Figure 9
Figure 10