eta RYAN Bedienungsanleitung Seite 24

GB
6) After charging, unplug the adaptor from the mains first and only then unplug the
connector from the appliance.
Optimize the working life of the battery
– Do not charge for more than 1 hour.
– Do not keep cord permanently plugged in.
– The appliance heats up during charging or operation, which is normal.
First select the attachment you want to use for cutting purposes. You have 5 different
cutting attachments with different uses to choose from. All these cutting attachments (B1,
B2, B3, B4, B5) are put on the appliance in the same manner. Follow instructions on pic. 3.
When removing the attachment, proceed reversely. Press lightly on the fixed attachment
from the front part of the attachment. This will release it, you can now remove it.
Cutting attachments B1 and B2 can be used with comb attachments with various length
of cutting. All these comb attachments C are put on in the same manner (follow the
instructions on pic. 4). When removing the comb attachment, proceed reversely (pic. 4).
Hair clipping (pic. 5).
– The trimmer can be operated from the outlet with the adaptor connected or only from the
charged battery. In case an attachment B gets blocked (or the blades A3), the appliance
must be turned off immediately and the cause of the block removed.
– The trimmer turns on and off with a switch A1. Turn the trimmer on only after all the
attachments have been properly placed and you are ready for trimming. Turn the trimmer
off immediately after use.
– We recommed oiling the blades with the oil D4 attached before first use.
– Before you start clipping, make sure that the head of the person whose hair you are
cutting is at the same level as your chest so that all parts of his/ her head are clearly
visible and within easy reach.
– Only use the clipper on dry hair.
– Do not use on freshly washed hair.
– Before you begin, comb the hair in the direction of growth.
– To achieve optimal clipping results, always move the clipper slowly through the hair
against the direction of hair growth.
– When the appliance is in operation, the symbols
power reaches minimum, the indicator
the battery.
Clipping with hair comb attachment
You may use 3 kinds of comb attachments C for trimming, depending on the attachment
(B1, B2) used.
1) Choose one of the two cutting attachments (B1, B2), on which you may then put on
the comb attachments C arbitrarily, depending on the desired haircut length. Put this
attachment on properly.
2) Put on the desired comb attachment C depending on the chosen size of the attachment.
Then you can turn on the appliance. Two of the C1a/b attachments has variable size of
the cut (1 – 20 mm).
3) If you are trimming for the first time, begin by trimming with an attachment of max.
length to prevent too short of a cut.
light is blue, when the battery
to 10x flashing blue. It is a signal to charge
24 / 54