Temperature Control And Adjustment; Before Operating - Beko LBI 2201 Gebrauchsanweisung

GB
Temperature control
and adjustment
Operating temperatures are controlled by the
thermostat knob (Fig. 2) and may be set
between 1 and 5, the coldest position.
When the appliance is switched on for the first
time, the thermostat should be adjusted so that,
after 24 hours, the average fridge temperature
is no higher than +5°C (+41°F ).
We recommend setting the thermostat half-way
between the minimum and maximum setting
and monitoring to obtain the desired temperature
i. e. towards maximum you will obtain a lower
temperature and vice versa. Some sections of
the fridge may be cooler or warmer ( such as
the salad crisper
and the top part of the cabinet ) which is quite
normal.
In ambient temperatures above 25°C (77°F),
especially in summer, turn the thermostat knob
towards 5. In ambient temperatures below
25°C (77°F) turn the thermostat knob to a half
way position.
Frequent door opening causes internal
temperatures to rise, so it is advisable to close
as soon as possible after use.

Before operating

Final Check
Before you start using the appliance check that:
1. The interior is dry and air can circulate freely
at the rear.
2. The interior is clean as recommended under
"Cleaning and care."
3. The plug has been inserted into the wall
socket and the electricity is switched on. When
the door is open the interior light will come on.
And note that:
4. You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also make some
(noise), whether the compressor is running or
not. This is quite normal.
5. Slight undulation of the top of the cabinet
is quite normal due to the manufacturing process
used; it is not a defect.
6. We recommend setting the thermostat knob
midway and monitor the temperature to ensure
the appliance maintains desired storage
temperatures (See section Temperature Control
and Adjustment).
7. Do not load the appliance immediately it is
switched on. Wait until the correct storage
temperature has been reached. We recommend
checking the temperature with an accurate
thermometer (see; Temperature Control and
Adjustment).
4
Instructions for use