Cadac SAFARI CHEF 2 6540H0 Benutzeranleitung Seite 6

• When attempting to light the appliance, make sure that the gas cartridge is
properly fitted before turning on the gas supply to the appliance.
•
To light the appliance using the piezo ignition, open the control valve on the
appliance by slowly turning it in an anti-clockwise direction and press the
piezo button in rapid succession to ignite the burner. If the burner fails to
ignite, press the piezo button again continuously whilst increasing the gas
flow by turning the control knob until the burner ignites. If the burner does
not ignite in the first 5 seconds, close the valve and wait 30 seconds before
trying again.
• To light the appliance manually, apply a flame to the burner using a BBQ
Lighter, turn the appliance control knob slowly in an anti-clockwise direction
until the burner lights (Fig. 1).
• Use the control knob to adjust the flame intensity to the desired level by
turning the knob clockwise to decrease the flame and anti-clockwise to
increase the flame.
• When not in use remove the gas cartridge.
• WARNING: Do not use any cooking surfaces on a high flame setting for
more than 10 minutes as this can damage the non-stick coatings.
7. Cooking Options
• There are five available cooking options (the 5th is an optional
accessory) with your Safari Chef 2 appliance. These are:
Barbecuing: This cooking option is ideal for fat-free barbecuing
of chicken, sausages, chops, kebabs, fish or vegetables.
For this type of cooking, place the fat pan onto the heat shield.
Place the BBQ grid onto the locators of the fat pan.
Caution: Please note that when cooking fatty meats some fat will
drip onto the unit which may cause flare-ups. Please use caution
when handling such meats. The cooking temperatures are easily
adjusted to suit your own requirements by turning the control
knob to regulate the degree of heat.
Frying: This option is ideal for stir-fries, fish, breakfast,
pancakes, prawns, paella and vegetables. For this type of
cooking, place the fat pan onto the heat shield. Place the flat
pan onto the locators of the fat pan. Please note that being a
shallow pan, it is not suitable for deep-frying. The easy clean
surface encourages the minimum use of fat for healthy cooking.
Oven Dome / Wok: The dome can be used as a wok, a lid
to create an oven on the BBQ, or a saucepan. For wok-style
cooking, place the dome upside-down directly onto the pot stand
and use to prepare stir-fries, pasta dishes or paella. To use the
dome as an oven lid place the dome over a meal cooking on
the BBQ option for convection style cooking. This is ideal for
roasting chicken, lamp, beef or pork. The dome can also be used
as a saucepan, to heat sauces, marinades, boil water, cook rice,
pasta etc. Place the dome upside-down directly onto the pot
stand.
Boiling: For this type of cooking, place the pot stand in its locator
grooves on the heat shield ensuring that it is properly seated.
Place a suitable pot (not less than 150mm diameter and not
more than 300mm diameter) or the Safari Chef 2 dome on the
pot stand. The fat pan is designed to be placed onto the dome to
act as a lid for the dome to boil food. One litre of water will boil
in approximately 6 minutes depending on the conditions, size of
pot used, etc. Note: When using small sized pots do not attempt
to use pots with plastic handles. Pot stand can also be used in the
fat pan.
Pizza Baking (Optional Accessory): For this type of cooking, place
the pot stand into the fat pan. The fat pan has been designed in
such a way that it can also be used as a windshield. Place the
pizza stone onto the pot stand. Pre-heat your pizza stone before use. Ensure
that food is at room temperature before placing it onto the pizza stone, DO
NOT put frozen food onto a heated pizza stone. Put the dome on to create an
oven effect for better heat distribution. For cooking methods when using the
pizza stone, please refer to the pizza stone user manual.
Pizza Baking
4 4
GB
Fig. 5