Switch The Device On / Off; Adjusting The Volume; Phono Mode - Reflexion HIF2002 Bedienungsanleitung

REMOTE CONTROL REPLACE BATTERY
The battery compartment is on the back of the
remote control.
1. Remove the battery door by pushing the
tab to the right and pulling out.
2. Insert a CR-2025 size battery (included)
into the battery compartment. Pay
attention to the polarity markings in the
battery compartment.
3. Replace the battery compartment door.

SWITCH THE DEVICE ON / OFF

Switching on:
Switching off:
NOTE:

If the device is in USB / CD / cassette mode without function / playback
for approx. 15 minutes, the device automatically switches to standby
mode (energy-saving mode).

Press the [Power] button to switch the device on again.

Please note that a low volume setting can be recognized as "no audio
signal" during playback. This affects the ability of the device to detect
signals and can also trigger an automatic switch to standby mode. In this
case, increase the volume.

ELECTROSTATIC DISCHARGE INSTRUCTIONS
SETTING THE FUNCTIONAL MODE
1. To select the desired function mode, press the [Function] key repeatedly.
2. The following function modes are available.
FM (VHF) / CD / USB / Phono (turntable) / Tape (cassette)

ADJUSTING THE VOLUME

1. To change the volume, turn the volume control [Volume] on the device or
press the [Vol- / Vol +] button on the remote control.

PHONO MODE

Preparation
1. Open the PROTECTIVE LID (1) of the device.
Press the [Power] button to switch on the device.
Hold down the [Power] button for approx. 3 seconds to switch off
the device.
33