Inhaltsverzeichnis
Werbung
56
2
To clean the coarse filter and the fine filter, use a
cleaning brush.
Step 1: Contra rotate the filter cylinder, and then lift
it up;
Step 2: Lift the main filter up;
Step 3: Lift the fine filter.
NOTE:
If do it from step1 to step 3, the filter system will be
removed; while if do it from step3 to step 1, the
filter system will be installed.
Caution! Never run the dishwasher without
filters.
Improper replacement of the filter may reduce the
performance level of the appliance and damage
dishes and utensils.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly,
for hard water chemicals can clog the spray arm
jets and bearings.
To remove the upper spray arm, hold the
•
nut, rotate the arm clockwise to remove it.
To remove the lower spray arm, pull out the
•
spray arm upward.
•
Wash the arms in soapy and warm water
and use a soft brush to clean the jets,
Replace them after rinsing thoroughly.
•
Protecting Against Freezing
If your dishwasher is left in an unheated place
during the winter, ask a service technician to:
•
Cut off electrical power to the dishwasher.
Remove fuses or trip circuit breaker,
Turn off the water supply and disconnect
•
the water inlet pipe from the faucet,
•
Drain water from the inlet pipe and faucet,
Reconnect the water inlet pipe to the
•
faucet.
Remove the plastic sump cover of the bottom tub.
Use a sponge to soak up water in the rubber boot
EN
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
