Hoonved AP 43 E Gebrauchs - Und Wartungsanweisungen Seite 30

ENGLISH
3) During rinsing, the boiler temperature is indicated and
the display LEDs light up in sequence;
By pressing the START "S3" button again, a new washing
cycle will begin;
This machine guarantees rinsing at temperatures ideal
for hygienic purposes;
indeed, if this is not sufficient, the washing cycle is au
tomatically extended so as to provide the necessary
conditions for optimum rinsing at 85°C.
The waiting time required to attain optimum temperature
can extend to a maximum of 8 minutes.
2.1.e.2 Interrupting the cycle
1) It is possible to pause the washing cycle in case of
EMERGENCY, by opening the door;
the message "F1" will appear on the display;
normal operations will resume on closing the door.
2 ) The cycle will also be interrupted by SWITCHING
OFF the machine using the "Q1" button.
3) On switching the machine back on, the LED indicating
the last cycle selected will light up, and the alarm
message "A1" will appear on the display;
this will disappear when a new cycle is begun.
At the end of the washing cycle, take out the basket and
shake it gently so as to remove the last drops left on the
washed items.
Allow items to dry and remove them from the basket
with clean hands.
Store all items on hygienic and completely stable su
faces.
30
I II III IIII
LC1 LC2 LC3 LC4
Part 2: For the operator
2.1.f Self-washing and Draining
At the end of the washing operations, TURN OFF the
machine pushing the "Q1" button .
Close the machine's door, press the START button "S3"
(approx. 5 sec.)and keep it pressed until the message
"C1" appears on the display, then release the "S3"
button;
The self cleaning and draining cycle will start, co
firmed by the flashing Leds on the display, with the
activation of the drain pump; the end of the phase will
be confirmed by the appearing of the message "OFF"
on the display. Maximum duration 2 1/2 min
2.1.g Manual draining
It is possible to empty the tank by carrying out the
manual draining cycle, during which only the drainage
pump mains active.
ATTENTION
This cycle can only be carried out by leaving the machi
ne SWITCHED ON and the tank full of water.
Close the machine's door and press the "S9" or CYCLE
button (approx. 5 sec.). Keep it pressed until the mes
sage "C2" appears on the display, then release the
"S9" or CICLE button;
The Drain cycle will start, confirmed by the flashing Leds
on the display; the end of the phase is confirmed by
the apearing of the message "OFF" on the display.
Maximum duration 1 min.
By pressing the "S9" or CYCLE button you can
interrupt the drainage cycle before the preset time
is up.