Maintenance - ATI SOL-D Bedienungsanleitung

MAINTENANCE

5.
Shower cleaning: use specific products for satin stainless steel and non-rough cloths, taking
care to clean following the direction of the veins to avoid damaging the surface. Avoid using abrasive
sponges and steel wool, or water that is very hard, dirty or full of debris. Avoid using chlorine-based
detergents (e.g. bleach).
Disassembly at the end of the season: the shower is not suitable for withstanding frost. At the
end of the summer season it is necessary to empty it completely and store it in a covered place
sheltered from the elements.
To empty the shower, lift and turn the mixer knob to the cold water position, then disconnect
the cold water inlet and wait for the shower to empty completely
Failure to empty during the winter season can cause the tank to break due to frost. Do not
use salt or other antifreeze methods.
IMPORTANT: if the appliance remains unused for a long time, it is advisable to protect it with
the protection bag from dirt and atmospheric agents. In summer, in particular if the appliance is
empty, it avoids the reaching of high temperatures inside the tank that might deform it.
Mixer cartridge replacement: when the mixer has problems, such as water loss or when it no
longer allows the temperature to be balanced, the internal cartridge may need replacement or simple
maintenance and cleaning: this guarantees long life and minimum effort in closing the tap. The
cartridge is in fact a component that is easily subject to wear: its functioning can be compromised by
the presence of limestone or debris present in the water (sand, for example).
Cartridge Replacement Sequence (FIG-5-1):
unscrew the screw underneath the handle and remove it
a)
unscrew the chrome ring nut
b)
unscrew the brass nut
c)
remove and replace the cartridge
d)
retighten the brass nut
e)
retighten the chrome ring
f)
mount the handle and fix it
g)
If it is necessary to replace the foot wash tap, avoid loosening the tightness between the
shower body and the fitting: in this case the fitting fixed to the shower body must be held in place with
a wrench (FIG-5-2)
Pag. 13 / 36
ENGLISH
210-0271 – edizione 2020-09