Technical Data; Warranty; Ec Declaration Of Conformity - GreenWorks G40 Bedienungshandbuch

EN
PROBLEM
The motor buzzes,
but you can not
start the machine.
There is no water.
8

TECHNICAL DATA

Model No.
Rated Voltage
Rated Pressure
Permissible Pres-
sure
Power Rating
Rated Water Flow
Maximum Water
Flow
Maximum Water In-
let Pressure
POSSIBLE SOLUTION
CAUSE
The supply volt- Make sure that on-
age is low. ly the pressure
washer operates
on the circuit.
The system has re- 1. Stop the ma-
maining pressure. chine.
2. Pull the gun
trigger on
spray wand to
release pres-
sure
3. Start the ma-
chine.
The voltage de- Disconnect the ex-
creases across ex- tension cord, and
tension cord. connect the ma-
chine directly into
the outlet.
You do not use the Speak to a person
machine for a long of an approved
time. service center.
There is remaining 1. Disconnect the
friction in compo- water supply.
nents. You can
2. Turn the ma-
hear a hum.
chine on for 2
or 3 seconds.
3. Repeat the
above step for
several times.
The water supply Turn the water
is off. supply on.
The garden hose is Make sure that the
blocked. garden hose is free
from blockage.
G40 G50
220-240V ~ 50 230V ~ 50 Hz
Hz
10 MPa 11 MPa
13.5 MPa 14.5 MPa
1900 W 2200 W
6.5 l/min 6.6 l/min
8 l/min 8.3 l/min
0.7 MPa 0.7 MPa
English
Maximum Water In-
let Temperature
Measured sound
pressure level
Measured sound
power level
Guaranteed sound
power level
Vibration
Protection Degree
9

WARRANTY

(The full warranty terms and conditions can be found on
Greenworks webpage)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
purchase. This warranty covers manufacturing faults. A faulty
product under warranty might be either repaired or replaced.
A unit that has been misused or used in other ways then
described in the owner's manual might be rejected for
warranty. Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not affected
by any additional warranty offered by a dealer or retailer.
A faulty product must be returned to the point of purchase in
order to claim for warranty, together with the proof of
purchase (receipt).
10 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name: GLOBGRO AB
Globe Group Europe
Address: Propellergatan 1, 211 15 Malmö, Sweden
Name and address of the person authorised to compile the
technical file:
Name: Peter Söderström
Address: Propellergatan 1, 211 15 Malmö, Sweden
Herewith we declare that the product
Category:
Model:
Serial number:
8
40 °C 40 °C
L = 82 dB(A), L = 82 dB(A),
pA pA
K = 3 dB(A) K = 3 dB(A)
pA pA
L = 90.1 dB(A) L = 90.7 dB(A)
wA wA
L = 94 dB(A) L = 94 dB(A)
wA.d wA.d
2
< 2.5 m/s , K = < 2.5 m/s
2 2
1.5 m/s 1.5 m/s
IPX 5 IPX 5
Double-insulated construction.
Pressure washer
G40/G50 （PWA111）
See product rating label
2
, K =