Use The Gun; Install The Nozzle; Install The Detergent Tank; Start The Machine - GreenWorks G40 Bedienungshandbuch

WARNING
• The water supply must come from the water main
• Do not use hot water
• Do not use water from ponds or lakes
WARNING
Do the local regulations when you connect the garden hose
to the water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
CAUTION
Inspect the filter in the water inlet connector before you
connect the garden hose
• If the filter is damaged, do not use the machine until the
filter is replaced.
• If the filter is dirty, clean the filter.
Figure 6.
1. Uncoil the garden hose.
2. Let the water flow through the garden hose for 30
seconds.
3. Turn the water supply off.
4. Install and tighten the end of the garden hose to the water
inlet connector.
CAUTION
There must be a minimum of 3 m of free hose between the
water inlet and the water supply.
4.2

USE THE GUN

Figure 2.
WARNING
For safe control, keep your hands on the gun at all times.
• Pull and hold the gun trigger to start the machine.
• Release the gun trigger to stop water flow through the
nozzle.
4.2.1 UNLOCK THE GUN TRIGGER
• Push backward the trigger safety button.
4.2.2 LOCK THE GUN TRIGGER
• Push forward the trigger safety button.
4.3

INSTALL THE NOZZLE

Figure 7.
English
Before you change the nozzle:
1. Pull the gun trigger to release water pressure.
2. Lock the trigger safety button on the gun.
3. Stop the mahcine.
Do not point the spray wand at your face or others'.
1. Push and hold the lock button on the spray wand.
2. Align the pin on the nozzle with the hole on the spray
wand.
3. Install the nozzle onto the spray wand.
4. Rotate the nozzle to adjust the spray shape.
4.4

INSTALL THE DETERGENT TANK

Figure 8.
Do not use household detergents, acids, alkalines, bleaches,
solvents, flammable material, or industrial grade solutions,
which can do damage to the pump.
Do the instructions on the solution bottle to prepare
detergent.
If it is necessary, use a funnel to prevent the spill of
detergent. Clean and dry the spilled detergent when you fill
it.
1. Put the detergent into the detergent tank.
2. Push and hold the lock button on the spray wand.
3. Install the detergent tank onto the spray wand.
Do not let detergent dry on the surface to prevent streaks.
4.5

START THE MACHINE

Figure 9.
Do not operate without the water supply connected.
5
WARNING
WARNING
WARNING
WARNING
NOTE
NOTE
CAUTION
EN