Stop The Machine; Maintenance; Nozzle Maintenance; Transportation And Storage - GreenWorks G40 Bedienungshandbuch

EN
Before you start the machine:
1. Turn the water supply on.
2. Pull the gun trigger to release air pressure.
3. If a stable stream of water comes out from the gun,
release the gun trigger.
1. Connect the machine to the power supply.
2. Set the power switch to the "ON" ( | ) position.
3. Turn the water supply on.
4. Pull the gun trigger.
4.6

STOP THE MACHINE

1. Release the gun trigger.
2. Set the power switch to the "OFF" (O) position.
If you do not use the machine：
• Stop the machine.
• Turn the water supply off.
• Disconnect the power cord from the outlet.
• Pull the gun trigger to release the remaining pressure
from the machine.
• Lock the trigger safety button.
5

MAINTENANCE

Before maintenance, make sure that you
• stop the machine.
• wait until all the moving parts stop.
• disconnect the plug from the power source.
Do not use strong solvents or detergents on the plastic
housing or components.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Replace the power cord by an approved service center.
5.1

NOZZLE MAINTENANCE

Figure 7.
CAUTION
WARNING
WARNING
WARNING
WARNING
WARNING
English
If there is too much pump pressure, the nozzle can become
clogged, you can feel a pulsing sensation while you pull the
gun trigger.
5.1.1 REMOVE THE NOZZLE
1. Push and hold the lock button on the spray wand.
2. Remove the nozzle from the spary wand.
5.1.2 CLEAN THE NOZZLE
1. Use a straight paper clip or cleaning tool to clean the
spray tip.
2. Flush and clean the unwanted materials out of the nozzle
with the garden hose.
3. Install the clean nozzle to the spray wand.
6 TRANSPORTATION AND
STORAGE
Disconnect the power cord before transportation and
storage.
6.1

MOVE THE MACHINE

• Point the spray wand in a safe direction.
• Only hold the machine with the handgrip.
6.2

STORE THE MACHINE

Make sure that the gun, the high pressure hose and the
pump are dry.
Make sure that children cannot come near the machine.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
• Disconnect the garden hose from machine.
• Wind the high pressure hose.
• Clean housing and the plastic components with a moist
and soft cloth.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• replace the damaged parts.
• tighten the bolts.
• speak to a person of an approved service center.
• Store the machine in a dry, isolated and frost-free area.
6
WARNING
WARNING
WARNING
NOTE