Makita DTD170 Betriebsanleitung Seite 9

Indicating the remaining battery
capacity
Only for battery cartridges with "B" at the end of the
model number
►
Fig.4: 1. Indicator lamps 2. Check button
Press the check
the battery cartridge
the remaining battery capacity. The indicator lamps light
up for few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Switch action
►
Fig.5: 1. Switch trigger
CAUTION:
Before installing the battery
cartridge into the tool, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
NOTE: The tool automatically stops if you keep pulling
the switch trigger for about 6 minutes.
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
►
Fig.6: 1. Lamp
►
Fig.7: 1. Button
Pull the switch
turn on the
turn off, release it. The lamp goes out
button on
to indicate
Remaining
capacity
Blinking
75 % to 100%
50 % to 75%
25 % to 50%
0 % to 25%
Charge the
battery.
The battery
may have
malfunctioned.
trigger to
lamp. To
approximately 10 seconds after releasing the switch
trigger.
To keep the lamp off, turn off the lamp status. To turn off
the lamp
and release
And then
button within 10 seconds. To turn on the
lamp status again, press the button
similarly.
NOTE: To
status,
When
up
switch
status
the
come
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Reversing switch action
►
Fig.8:
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may damage
the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the
neutral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side
or from
for counterclockwise rotation.
When the
is
position, the switch trigger cannot be pulled.
A mode
"A
mode
an
for
In this mode, the tool drives a screw with low-speed
rotation at
tool starts
rotation speed increases and reaches the maximum
speed.
9 ENGLISH
status, first
the switch
press the
confirm the
pull the
the lamp
by pulling
trigger, the
is ON.
lamp does
on, the lamp status is OFF.
1. Reversing switch lever
for clockwise rotation
the B
reversing switch
in the
mode)"
(assist
easy-to-use
driving screws with good control.
first. After
to impact,
pull
trigger.
again
lamp
trigger.
lights
the
lamp
When
not
side
lever
neutral
is
mode
the
the