Makita DTD170 Betriebsanleitung Seite 11

Impact force grade displayed
on panel
Max
Hard
Medium
Soft
T mode
A mode
NOTE: T mode
the tool
mode and
are the
NOTE: When all
the tool
power. The
extent that the tool does not operate.
NOTE: While pulling
cannot be
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
►
Fig.11
Use only driver
that has
portion shown
figure. Do
Maximum blows
-1
3,800 min (/min)
-1
3,600 min (/min)
-1
2,600 min (/min)
-1
1,100 min (/min)
-1
2,600 min (/min)
-1
3,800 min (/min)
and A mode
rotates clockwise. When
A mode, the
same as max
lamps on the
is turned off
impact force grade can be checked by pulling the switch trigger to the
the switch trigger,
changed.
bit/socket bit
inserting
in the
not use
11 ENGLISH
Purpose
Tightening with the maximum
force and speed.
Tightening with less force and
speed than Max mode (easier
to control than Max mode).
Tightening when a
good
finishing is
needed.
Tightening with less force to
avoid screw thread breakage.
Tightening when speed and
good finishing are
needed.
Tightening screws with better
control.
is available
rotating counterclockwise
impact force
mode.
switch panel
to save
the impact
any
bit.
For tool with shallow driver bit hole
A=12mm B=9mm
For tool with deep driver bit hole
A=17mm B=14mm
A=12mm B=9mm
Example of application
Tightening underwork
materials, tightening long
screws, tightening bolts.
Tightening underwork
materials, tightening long
screws, tightening bolts.
Tightening finishing
boards,
plaster boards.
Tightening sash screws,
tightening small screws such as
M6.
Tightening self drilling screws.
Tightening long screws.
only when
in
and speed
go out,
the battery
force grade
other driver bit/ socket
Use only these type of driver
bit. Follow the procedure 1.
(Note) Bit-piece is not
necessary.
To install these types of driver
bits, follow the procedure 1.
To install these types of driver
bits, follow the procedure 2.
(Note) Bit-piece is necessary
for installing the bit.
T