Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MoUNTING & CoNNECTIoNS
Add a main fuse holder with appropriate fuse volume to the (+) power cable
in a distance of not more than 30 cm from the positive battery pole.
Note that the amp-module generates heat, so a well ventilated mounting place
n
is necessary or it will easily overheat.
Keep the wire connections as short as possible, with sufficient length, in order to
n
minimize power losses and provide a higher audio output of the system.
To minimize damage to the cables, take care that they do not pass through sharp
n
edged metal. Use rubber grommets were required.
Lay all cables as far away as possible from the ignition cables, modules in the boot
n
and under the dashboard, as these create interference.
Keep the length of the power cable as short as possible.
n
The power cable should have at least a cable cross section of 10mm
n
AWG). Smaller cross sections are reducing the output power, are causing
distortions and may be triggering the overheat protection of the amp-module.
– 6 –
(8 Gauge
2
Werbung
Inhaltsverzeichnis
