Operation - EINHELL BT-ED 380 E Bedienungsanleitung

Anleitung BT-ED_380_E_SPK7:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Drill chuck
2. Locking button
3. ON/OFF switch
4. Speed controller
5. Clockwise/Counter-clockwise switch
6. Chuck key
3. Proper use
The drill is designed for drilling holes into wood, iron
and non-ferrous metals using the appropriate bits.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
8
30.04.2008 9:53 Uhr Seite 8
4. Technical data
Mains voltage:
Power input:
Idling speed:
Drilling capacity
Protection class:
Weight:
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the drill bit (Fig. 2)
Always pull the power plug before making
adjustments to the equipment.
Undo the chuck by turning it anti-clockwise with
the supplied chuck key (6).
To ensure that it is perfectly positioned the drill bit
or tool should be inserted as far as possible into
the chuck. After inserting the drill bit or tool,
tighten the chuck (1) by turning the chuck key (6)
clockwise until the drill bit or tool is secure. Check
that the drill bit is secure in the chuck (1).
Check at regular intervals that the drill bit or tool is
secure (pull the mains plug).

6. Operation

6.1 ON/OFF switch (Fig. 3/Item 3)
First fit a suitable drill bit into the tool (see 5.1).
Connect the mains plug to a suitable socket.
Position the drill in the position you wish to drill.
To switch on:
Press the ON/OFF switch (3)
Continuous operation:
Secure the ON/OFF switch (3) with the locking
button (2).
To switch off:
Press the ON/OFF switch (3) briefly.
230 V ~ 50 Hz
380 W
0-3,000 min -1
Steel 10 mm
Wood 16 mm
II /
1.3 kg