Switching Off; Safety Guidelines - VINCENT KHV-200 Bedienungsanleitung

This appliance was produced under strict quality controls.
It complies with all established international safety standards.
Nonetheless, the following instructions should be fully read and
observed in order to prevent any hazard:
Do not open the appliance! Risk of electric shock!
There are no parts in the appliance that require maintenance by the user.
Maintenance/Alterations
All equipment that is connected to the domestic
mains voltage can be dangerous to the user if
not handled properly. Leave maintenance work
to qualified professionals. The product is only
permitted for connection to AC 230 Volt/50 Hz,
for earthed sockets and use in enclosed areas.
Altering the product or manipulating its serial
number voids the warranty. After a fault, leave
the appliance's fuse to be replaced only by a
professional with one of the same kind.
Power Cable Connection
Always pull the plug and never the power cable if
you want to disconnect the appliance from the
mains power. Make sure when setting up the appli-
ance that the power cable is not squashed, sever-
ely bent or damaged by sharp edges. Do not touch
the power lead with wet or damp hands. Use the
power cable supplied or another one from Vincent.

Switching Off

Switch the appliance off every time before you
connect or remove other components or loudspea-
kers, disconnect or connect it to the mains power,
leave it unused for a longer period or want to clean
its outside. On all amplifiers and receivers, wait
approx. 1 minute after this before disconnecting or
reconnecting the cable.
Moisture/Heat/Vibration
Contact of electrically operated equipment with
liquids, moisture, rain or water vapour is dange-
20

SAFETY GUIDELINES

rous for such equipment and the user and must be
avoided without fail. Take care that no liquids or
objects get inside the appliance (ventilation slots
etc.). It must be disconnected from the mains pow-
er immediately and examined by a professional if
this happens. Never expose the appliance to high
temperatures (direct sunshine) or strong vibration.
Heat Build-up
Make sure that a gap of 5 cm remains around the
appliance and that the surrounding air can circulate
(do not install in enclosed cupboards). Vents must
not be covered up.
Volume
The maximum tolerable volume is always reached
well below the maximum possible setting on the
amplifier. Be careful with the volume setting, the-
refore, in order to prevent damage to hearing. So
that you do not expose yourself to high volumes
unintentionally, always set to a low level before ch-
anging the input channel.
Cleaning
Pull out the power plug before cleaning the outside
of the product. Whenever possible, use a soft,
lintfree cloth that has been dampened. Do not use
abrasives, solvents, thinners, flammable chemicals,
polishes and other cleaning products that leave
marks.