VINCENT KHV-200 Bedienungsanleitung Seite 23

1
2
1. BALANCE: Balance-Control
This ist he knob to control the balance of the left
and right speaker.
2. WARM-UP display and POWER-LED
This LED flashes for approx. 30 seconds during
warm-up after turning the unit on and stays
permanently on as long as the unit is turned on
and in ready for use.
3. POWER:
This is the main power switch for turning on and
off the device. The KHV-200 is separated from the
mains voltage when switched off and cannot be
set into a standby state.
FRONT VIEW
3 4 5
4. Tube window
5. INPUT: Input Selector
This push button allows you to choose one of the
two input sources (CD, AUX).
6. VOLUME: Volume dial
This is the knob for the adjustment of the main
volume level of the system. It consequently controls
the volume of the headphones and the signal of
the stereo preamplifier output (10).
7. PHONES: Headphone socket
Headphones with an impedance of at least
32 Ohm can be connected to this 6.3 mm jack
socket.
6
7
23