IKEA STYRBAR Handbuch Seite 5

Factory reset your devices
For light sources:
Toggle the main switch 6 times.
For remote control:
Press the pairing button 4 times within 5 seconds.
Synchronizing
If your light source becomes unsynchronized, a long
press on the left (<) or right (>) buttons will return
the light source to its default setting (2700K).
Changing the battery
When the remote control is used regularly and as
intended, the batteries will last for approximately
2 years.
When it's time to replace the battery, a red LED
indicator will flash when you press any button on
the remote control.
Open the battery lid and replace the battery with
two new AAA/HR03 batteries.
Caution!
Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according
to the instructions.
Important!
• The remote control is for indoor use only and
can be used in temperatures ranging from 0ºC
to 40 ºC.
• Do not leave the remote control in direct sunlight
or near any heat source, as it may overheat.
• The range between the remote control and the
receiver are measured in open air.
5