Troubleshooting - AEG FSE84717P Benutzerinformation

24 www.aeg.com

11. TROUBLESHOOTING

WARNING!
Improper repair of the
appliance may pose a
danger to the safety of the
user. Any repairs must be
performed by qualified
personnel.
The majority of problems that may
occur can be solved without the need
Problem and alarm code
You cannot activate the ap‐
pliance.
The programme does not
start.
The appliance does not fill
with water.
The display shows
i10 or Error i11 and No in‐
take of water.
The appliance does not
drain the water.
The display shows
i20 and Water is not drain‐
ing.
The anti-flood device is on.
The display shows
i30 and Risk of flood de‐
tected.
Malfunction of the water lev‐
el detection sensor.
The display shows i41 - i44.
Possible cause and solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse
box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the
end of the countdown.
• The appliance recharges the resin inside the water soft‐
ener. The duration of the procedure is approximately 5
minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
, Error
authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clogged.
• Make sure that the drain hose has no kinks or bends.
, Error
• Close the water tap and contact an Authorised Service
Centre.
, Error
• Make sure that the filters are clean.
• Switch the appliance off and on.
to contact an Authorised Service
Centre.
Refer to the below table for information
on possible problems.
With some problems, the display shows
an alarm code.