Table; Adjusting Specified Drill Depht; Feed Spring Adjustment - HOLZMANN-MASCHINEN SB 4132SM Betriebsanleitung

14.2.2 Table

1. Loosen the Support Clamp (24).
2. Turn the Crank (9) to move the Table (13) to the desired height.
3. Tighten the Support Clamp.
4. To tilt the Table, loosen Hex Bolt and turn the Table. The scale can be used to approximate the
angle. Tighten the Hex Bolt.

14.2.3 Adjusting specified drill depht

1. Set DEPTH SCALE INDICATOR (16) to Zero.
2. Move Chuck downwards with FEED HANDLE (6) until desired depth is reached.
3. Read depth off the DEPTH SCALE INDICATOR (16)
4. Tighten the DEPTH SCALE LOCK (17).

14.2.4 Feed spring adjustment

You can adjust the feed tension with the FEED SPRING ADJUSTMENT without removing the
SPRING CAP (20). This makes sense when the quill returns too fast or too slow
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
43
SB 4132SM