Using The Humidifier; Switch The Humidifier On And Off; Water Level; Refill Water - Philips HU4801 Benutzerhandbuch

» The speed light and the
humidifier are on (fig f).
» The speed light is off.
» The humidifier is off.
•
•
4 Using the
humidifier
Switch the humidifier on
and off
1
Put the plug in the wall socket.
2
Turn the control knob to low
speed or high speed
3
Turn the control knob to OFF.
Note
The humidifier releases very fine invisible
mist, so it is normal that you cannot see
the mist.

Water level

When there is not enough water in the
water tank, the speed light will be off
and the humidifier stops working. The
control knob stays at the chosen speed.
When you refill water, the humidifier will
resume work at the chosen speed.
Note
It is normal to find some water left in the
tank.
EN
6
it (fig g).
and lift it up (fig b).
(fig e).
(fig c).
water tank (fig d).
•
•
•

Refill water

Water level can be observed through
the transparent water tank window.
1
Switch off the humidifier and unplug
2
Hold by both sides of the upper unit
3
You can observe the water level
through the transparent water tank
window. Fill the water tank with cold
tap water until the water reaches
the maximum water indication level
When filling water, do not exceed the
maximum water level, or water might leak
from the drain hole and air inlets.
Do not shake the water tank when
moving it, or water might leak from the
drain hole and air inlets.
Do not fill water through the air outlets
on top of the humidifier.
4
Place the upper unit back onto the
Note