Becker Centronic UnitControl EC611 Montage- Und Betriebsanleitung Seite 21

2 2 2 2
2 2 2 2
Briefly press the "Bell" button so that the code button is
ready for operation.
▻ The blue LED lights up.
Now enter the programming code. (Factory setting
2222)
▻ The blue LED lights up.
Now press the "Bell" button.
▻ The blue LED goes out and the green LED
lights up.
▻ The receiver confirms once.
▻ The green LED lights up, followed by the blue
one.
▻ Both LEDs go out.
Briefly press the "Bell" button so that the code button is
ready for operation again.
▻ The blue LED lights up.
Now enter the programming code. (Factory setting
2222)
▻ The blue LED lights up.
Now press the "Bell" button.
▻ The blue LED goes out and the green LED
lights up.
▻ The receiver confirms twice.
▻ The green LED lights up, followed by the blue
one.
▻ Both LEDs go out.
► The receiver has now been programmed.
21 - en