Federal Communication Commission Interference Statement - Husqvarna BLi100C Bedienungsanweisung

Radio frequency data
Frequency range, MHz
Output power, dBm
Approved battery chargers for the product
Battery charger
Mains voltage, V
Frequency, Hz
Power, W

Federal Communication Commission Interference Statement

Federal Communication Commission
Interference Statement
For USA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference; and (2)
This device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
CAUTION: Changes/Modifications not approved
by the responsible party could void the user's
authority to operate the equipment.
545 - 005 - 12.09.2018
BLi100C
2402-2480
3.7
QC330
100-240
50-60
330
Federal Communication Commission
Interference Statement
For Canada
This device complies with Industry Canada's licence-
exempt RSSs. Operation is subject to the following two
conditions:
•
•
This radio transmitter (identify the device by certification
number) has been approved by In-dustry Canada to
operate with the antenna types listed below with the
maximum permissi-ble gain indicated. Antenna types not
included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly
prohibited for use with this device.
Approved antenna type
2.4-GHz Inverted F-Anten-
na (PCB)
BLi200C
2402-2480
3.7
QC500
100-240
50-60
500
This device may not cause interference; and
This device must accept any interference, including
interference that may cause un-desired operation of
the device.
CAUTION: Changes/Modifications not approved
by the responsible party could void the user's
authority to operate the equipment.
BLi300C
2402-2480
3.7
Maximum permissible an-
tenna gain (dBi)
+3.3
7