Federal Communication Commission Interference Statement - Husqvarna BLi100C Bedienungsanweisung

Federal Communication Commission Interference Statement

Federal Communication Commission
Interference Statement
For USA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause interference; and (2) This
device must accept any interference, including
interference that may cause undesired operation of the
device.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
CAUTION: Changes/Modifications not
approved by the responsible party could
void the user's authority to operate the
equipment.
Federal Communication Commission
Interference Statement
For Canada
This device complies with Industry Canada's licence-
exempt RSSs. Operation is subject to the following two
conditions:
• This device may not cause interference; and
• This device must accept any interference, including
interference that may cause un-desired operation of
the device.
This radio transmitter (identify the device by certification
number) has been approved by In-dustry Canada to
operate with the antenna types listed below with the
maximum permissi-ble gain indicated. Antenna types not
included in this list, having a gain greater than the
8
maximum gain indicated for that type, are strictly
prohibited for use with this device.
Approved antenna type
2.4-GHz Inverted F-An-
tenna (PCB)
CAUTION: Changes/Modifications not
approved by the responsible party could
void the user's authority to operate the
equipment.
Maximum permissible an-
tenna gain (dBi)
+3.3
545 - 003 - 11.05.2018