getAir Smart Bedienungsanleitung Seite 22

• Insert the inside cover into the mount-
ing tube with the opening facing
upwards or put the front panel back on
if cover is permanently mounted.
• Switch the system on again at the
control unit.
Window reveal version
• Unscrew the window reveal grille.
• Remove the prefilter from the window
reveal grille.
• Check the prefilter; clean or replace if
necessary.
• Reinsert the prefilter into window reveal
grille.
• Reinstall the window reveal grille.
INFORMATION
The window reveal grille fins must route the
airflow away from the building.
Special loft/cellar solution
• Switch off the system at the control
unit.
22
• Remove the inside cover from the
mounting tube or, in the case of perma-
nently mounted covers, remove their
front panel.
• Unplug the connector from the fan.
• Without damaging the cable, pull out
the fan and heat exchanger at the
bracket.
• Check the condensate drain in the bend;
remove any condensate.
• Without damaging the cable, push
the heat exchanger carefully into the
mounting tube as far as it will go.
CAUTION
Risk of damage from blocked condensate drain!
• Never push the units into the bend via the
condensate drain.
• Without damaging the cable, insert the
fan carefully into mounting tube.
• Insert the fan connector and push the
fan carefully up to the heat exchanger in
the mounting tube.
• Insert the inside cover into the mount-
ing tube with the opening facing
upwards or put the front panel back on
if cover is permanently mounted.
• Switch the system on again at the
control unit.