Sharp XG-C40XU Serviceanleitung Seite 8

XG-C40XU 1
( )
XG-C40XE ( 1 )
No. Adjusting point
26 Colour system
performance
check
27 Video system
performance
check
28 Audio system
performance
check
29 RGB
performance
check
30 Off-timer
performance
check
31 Thermistor
performance
check
32 Automatic
synchronization
33 Keystone
correction
performance
check
34 Factory settings
Downloaded from www.Manualslib.com
Adjusting conditions
1. Receive the colour bar sig-
nal.
1. Receive the monoscope pat-
tern signal.
1. Receive the RGB signal.
1. Heat the thermistor using a
dryer.
1. Receive the PHASE check
pattern signal.
manuals search engine
Adjusting procedure
» In the process mode and select L1. Check the col-
our and tint.
» In the process mode and select L2. Check the pic-
ture, brightness and sharpness.
» In the process mode nad select L3. Check the bass,
treble.
» In the process mode and select L4. Check the pic-
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.
» In the process mode and select OFF. Make sure that
the off-timer starts with "5" (minutes), counts down each
minute in 1 second, and turns off the set at "0".
» Make sure the "TEMP" is displayed.
» Call the VGA/SVGA/XGA/SXGA mode and make
sure that the clock, phase, horizontal and vertical
positions can be automatically adjusted.
» Make sure the keystone correction functions well.
» Make the following settings.
Process
Remote controller setting
adjustment
S3 "Factory setting 3"(XG-C40XE1)
S4 "Factory setting 4"(XG-C40XU1)
8