Using The Alarm - Wörlein SOUNDMASTER DAB450 Bedienungsanleitung

Setting the alarm (in DAB mode only)
There are 2 alarm settings available.
Press and release the 'Alarm' button, 'Alarm 1 Setup' is displayed. Press and release the 'Select'
1.
button.
Note: Press and release the 'Alarm' button twice to set Alarm 2.
'Alarm 1 Wizard, On time' is displayed and the hour digits for the alarm will flash.
2.
Use the 'Prev' and 'Next' buttons to display the hour for the alarm. Press and release the 'Select'
3.
button.
The minute digits for the alarm will flash. Use the 'Prev' and 'Next' buttons to display the minutes for
4.
the alarm. Press and release the 'Select' button.
Use the 'Prev' and 'Next' buttons to display the duration for the alarm. You can choose from 15, 30, 45,
5.
60 and 90 minutes. Press and release the 'Select' button.
Use the 'Prev' and 'Next' buttons to display the sound source for the alarm. You can choose from
6.
Buzzer or DAB. Press and release the 'Select' button.
Use the 'Prev' and 'Next' buttons to display the frequency for the alarm. You can choose from Daily,
7.
Once, Weekends or Weekdays. Press and release the 'Select' button.
Note: If you choose Once, you will be prompted to set the date for the alarm.
Use the 'Prev' and 'Next' buttons to display the volume setting for the alarm. Press and release the
8.
'Select' button.
Note: Remember to set the alarm radio volume to one that will wake you. The alarm volume will
increase progressively until it reaches the alarm volume you have set.
'Alarm 1 Wizard' is displayed again, together with 'Alarm On (or Off)'. Use the 'Prev' and 'Next' buttons
9.
to display 'Alarm On' or 'Off'. Press and release the 'Select' button. 'Alarm Saved' is displayed.
10. In Standby mode a bell symbol in the top right of the display, together with the digit '1' or '2' will confirm
when an alarm has been set.
Note: If the time is not set or has failed to update from the radio signal, 'Time is not set' will be displayed when
you try to set the alarm. The radio will then prompt you to set the time. An alarm can only be set after the time
has been set.
When the unit is set to "Off" with the rotate 'On/Off' wheel, there is no alarm function!
Stop the alarm
When the alarm sounds press and release the 'Standby' button. Alternatively, you can press and release the
'Snooze' button to 'Snooze' (see Snooze function below).
Note: If you press the 'Standby' button to stop the alarm, the alarm symbol will remain in the display and the alarm
will sound again at the same time the next day unless it was set for 'Once' only.
Snooze
When the alarm sounds press and release the 'Snooze' button to Snooze. The Snooze time countdown will be
displayed and the alarm will sound again in approximately 5 minutes. To extend the snooze interval from the
default 5 minutes, press the "Sleep / Snooze" button repeatedly after the alarm has been activated to scroll
through the options available (5, 10, and 15 minutes).
Turn off the alarm
In Standby mode:
Briefly press and release the 'Alarm' button repeatedly to turn Alarm 1 and Alarm 2 'On' or 'Off'. Press and release
the 'Select' button. 'Alarm Saved' is displayed.
Alternatively, follow the steps for 'Setting an Alarm' and select 'Off' in step 9.

USING THE ALARM

5
DAB450 / English Instruction Manual