Bosch PSS 28 A Bedienungsanleitung Seite 9

Initial Operation
Observe correct mains voltage: The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
Switching On and Off
To start the machine, push the On/Off switch 2
and keep it pushed.
Lock the pushed On/Off switch 2 by pressing the
lock-on button 4.
To switch off the machine, release the On/Off
switch 2 or push and release it then.
Oscillating Rate Selection (PSS 28 AE)
With the knob 3, the required oscillation rate can
be selected (also while running).
The required oscillation rate is dependent on the
material and is to be determined by a practical
trial (See the applications table at the end of the
operating instructions).
Operating Instructions
Before any work on the machine itself, pull
the mains plug.
The removal performance when sanding is deter-
mined primarily by the selection of the sanding
sheet and the oscillation rate (PSS 28 AE).
Excessive sanding pressure does not lead to in-
creased sanding capacity, but to increased wear
of the machine and the sanding sheet.
A sanding sheet that has been used for metal
should not be used for other materials.
Use only original Bosch sanding sheets and ac-
cessories.
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep the
machine and the ventilation slots clean.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit order number
given on the nameplate of the machine.
9 • 2 609 932 012 • TMS • 17.12.01
Downloaded from www.Manualslib.com manuals search engine
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
strain relief
live = brown
neutral = blue
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine it must be
disposed of safely.
Environmental Protection
Recycle raw materials instead of disposing as
waste.
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
The plastic components are labelled for catego-
rized recycling.
Declaration of Conformity
We declare under our sole responsibility that this
product is in conformity with the following stand-
ards or standardization documents: EN 50 144
according to the provisions of the directives
89/336/EEC, 98/37/EC.
Dr. Gerhard Felten
Robert Bosch GmbH, Geschäftsbereich Elektrowerkzeuge
Subject to change without notice
English - 3
To be fitted
by qualified
professional only
Dr. Eckerhard Strötgen