Bosch PSS 28 A Bedienungsanleitung Seite 7

Tool Specifications
Orbital sander
Order number
Rated power
Output power
Oscillating Rate Selection
Oscillations
No-load speed
Oscillation range-Ø
Sanding sheet:
-Velcro attachment
-Clamping attachment
Weight (without accessories) approx. [kg]
Protection class
Machine Elements
1 Auxiliary handle
2 On/Off switch
3 Thumb wheel for oscillating rate selection
(PSS 28 AE)
4 Lock-on button for On/Off switch
5 Dust box (micro filtersystem)
6 Extraction adapter
7 Clamping lever
8 Sanding plate
9 Sanding sheet (without Velcro attachment)*
10 Sanding sheet (Velcro attachment)*
11 Outlet piece
12 Latching lever
13 Filter element (micro filtersystem)
14 Reducer
15 Hole punching tool
* Accessory
* Not all of the accessories illustrated or described are
included as standard delivery.
Noise/Vibration Information
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the product is 79 dB (A).
The noise level when working can exceed
85 dB (A).
Wear ear protection!
The typical weighted acceleration is 5 m/s
Intended Use
The machine is intended for the dry sanding of
surfaces of wood, plastic and filler as well as for
painter surfaces.
7 • 2 609 932 012 • TMS • 17.12.01
Downloaded from www.Manualslib.com
[W]
[W]
[opm]
[rpm]
[mm]
[mm]
[mm]
manuals search engine
PSS 28 A
0 603 285 2..
250
110
–
20 000
10 000
2.4
115 x 230
115 x 280
2.0
/ II
general safety notes in the enclosed booklet
must be observed.
Wear safety goggles.
The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
Dust from light alloys can burn or explode. Al-
ways keep the work place clean, as blends of
materials are particularly dangerous.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
The machine can be used only for dry sanding.
Insert the mains plug only when the machine is
2
.
switched off.
Always direct the cable to the rear away from
the machine.
Do not work with materials containing asbes-
tos.
English - 1
PSS 28 AE
0 603 285 5..
250
110
•
14 000 – 20 000
7 000 – 10 000
2.4
115 x 230
115 x 280
2.0
/ II
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the