Cleaning And Maintenance; Flushing Your Aquatrio - Philips AquaTrio FC7070 Benutzerhandbuch

5.6.1 Important to know
To reset the active protection system you need
to open and close the mopping nozzle lid. Make
sure you always remove any object from between
the mopping brushes before you switch on the
appliance.
6 Cleaning and
maintenance
A
Danger:
Never immerse the mopping nozzle or the body
of the appliance in water or any other liquid, nor
rinse it under the tap to prevent electric shocks.
B
Warning:
The plug must be removed from the socket-outlet
before cleaning or maintaining the appliance.

6.1 Flushing your AquaTrio

To clean the inside of the AquaTrio, you have to
lush the appliance. You need the lushing tray to
lush the appliance.
6.1.1 Important to know
•
We strongly advise you to lush the appliance
after every use to prevent dirt from
accumulating and bacteria from growing inside.
If you do not lush the appliance after every
use, this may lead to an unpleasant smell.
14
6.1.2 Flushing
switch off the appliance, place the appliance
1
upright in parking position ('click') and pull the
plug out of the wall socket.
To prevent interruption of the lushing
2
process, ill the clean water tank (see chapter
'Preparing for use', section 'Filling the clean
water tank') or empty the dirty water tank
(see chapter 'Using your AquaTrio', section
'Emptying the dirty water tank'). Interruption
of the lushing process has a negative effect on
the result.
Place the appliance on the lushing tray. Fill a
3
measuring cup with 300ml of water.
E
Tip:
If you wish, you can add some liquid loor
cleaner to the water.
Pour the water slowly into the lushing tray.
4
Make sure the water level does not exceed
the MAX indication. If the mopping brushes
become too wet, the active protection system
is activated.
Put the mains plug in the wall socket and
5
switch on the appliance. Let the appliance
operate until the water in the lushing tray is
used up. This takes approximately 15 seconds.