Philips AquaTrio FC7070 Benutzerhandbuch Seite 28

Problem
The appliance
does not take
up water when
I lush the
mopping nozzle.
The tank full/
tank empty light
starts lashing
and the appliance
switches off
while lushing the
mopping nozzle.
The tank full/tank
empty light lights
up continuously
and the appliance
switches off
while lushing the
mopping nozzle.
I cannot move
the appliance
forwards or
backwards.
I cannot ind the
vacuum cleaning
function.
D Note:
If the above solutions did not solve your problem, please visit www.philips.com/support or
contact the Philips Consumer Care Centre in your country.
28
Possible cause
You poured too
much water into
the lushing tray or
you poured it in too
fast. This causes the
mopping brushes
to become too wet.
When the brushes
are too wet, the
active protection
system is activated.
The mopping
brushes stopped
rotating because they
encountered too
heavy resistance.
The clean water tank
is empty.
The dirty water tank
is full.
One or more wheels
may be blocked by a
small object.
There is no separate
vacuum cleaning
function.
solution
switch off the appliance, put the appliance upright in
parking position ('click'), and pull the plug out of the
wall socket. Remove the mopping brushes from the
mopping nozzle and remove excess water from the
mopping brushes by squeezing them over a sink (see
chapter 'Cleaning and maintenance', section 'Cleaning the
mopping nozzle'). Then you can reinsert the mopping
brushes, reinsert the mopping brush cover, close the
mopping nozzle lid and switch on the appliance again
(see chapter 'Cleaning and maintenance', section
'Reassembling the mopping nozzle'). If this does not work,
let the mopping brushes dry (see chapter 'Cleaning and
maintenance', section 'Cleaning the mopping nozzle').
Reill the clean water tank (see chapter 'Preparing for
use', section 'Filling the clean water tank') and start the
lushing procedure again (see chapter 'Cleaning and
maintenance', section 'Flushing your AquaTrio').
Empty the dirty water tank (see chapter 'Using your
AquaTrio', section 'Emptying the dirty water tank') and
start the lushing procedure again (see chapter 'Cleaning
and maintenance', section 'Flushing your AquaTrio').
switch off and unplug the appliance and then put it on its
side. Make sure the dirty water tank is empty when you
put the appliance on its side, otherwise wastewater may
leak out of the dirty water tank. Check what is blocking
the wheel(s). Remove any object that could block the
wheel(s). Put the appliance upright again and resume
cleaning.
When you switch on the appliance, the mopping and the
vacuum cleaning functions work at the same time.