Philips AquaTrio FC7070 Benutzerhandbuch Seite 24

Problem
The appliance
does not clean as
well as it used to.
24
Possible cause
The active protection
system may have
been activated for
three reasons: (1) the
appliance picked up
a foreign object, (2)
the mopping brushes
are too wet or (3)
you have moved the
appliance over a carpet.
The mopping brushes
automatically stopped
rotating because they
encountered too
heavy resistance. The
appliance continues
to make a sound,
but it does not work
properly.
The active protection
system has been
activated because the
brushes are too wet.
The mopping brushes
automatically stopped
rotating because they
encountered too
heavy resistance.
The mopping nozzle
lid is not closed
properly. The sound
of the appliance
decreases and the
appliance no longer
applies water to the
loor because the
mopping brushes do
not rotate and the
appliance does not
mop up anything.
solution
Release the power-on button to switch off the appliance.
Put the appliance upright in parking position ('click') and
pull the plug out of the wall socket. Open the mopping
nozzle lid, remove the mopping brush cover and remove
the object. Reinsert the mopping brush cover, close the
mopping nozzle lid, put the plug in the wall socket and
switch on the appliance again (see chapter 'Using your
AquaTrio', section 'Active protection system is activated').
If you ind no object, the active protection system may
have been activated because the mopping brushes are
too wet (see next cause and solution) or because you
moved the appliance over a carpet. Pull the plug out
of the wall socket, open and close the mopping nozzle
lid, put the plug in the wall socket again, switch on the
appliance and start cleaning again.
If the above solutions did not help and the appliance still
does not work, switch on the appliance for at least 10
seconds. Then open and close the mopping nozzle lid,
switch on the appliance and start cleaning again.
Release the power-on button to switch off the appliance.
Put the appliance upright in parking position ('click') and
pull the plug out of the wall socket. Remove the mopping
brushes from the mopping nozzle and remove excess
water from the mopping brushes by squeezing them over
a sink (see chapter 'Cleaning and maintenance', section
'Cleaning the mopping nozzle'). Then you can reinsert the
mopping brushes, reinsert the mopping brush cover, close
the mopping nozzle lid, put the plug in the wall socket
and switch on the appliance again (see chapter 'Cleaning
and maintenance', section 'Reassembling the mopping
nozzle'). If this does not work, let the mopping brushes
dry (see chapter 'Cleaning and maintenance', section
'Cleaning the mopping nozzle').
Make sure the mopping brushes and the mopping brush
cover are assembled correctly. Close the mopping nozzle
lid properly. Make sure you press the lid until it locks with
a click (see chapter 'Cleaning and maintenance', section
'Reassembling the mopping nozzle').