Disconnecting A Gas Cylinder - Navigator PIT BOSS PB1230G Handbuch

5. Apply the soapy water mixture to the following:
• Supply tank (cylinder) welds
• Connection nut to tank valve
• Back side of connection nut to brass nipple
• Brass nipple connection into regulator
• Tank valve to cylinder
• Regulator connections to gas supply hose
6. Check each place listed for bubbles, which indicates a leak. Large leaks may not be
detected by bubbles but should produce a rushing sound or gas smell.
7. Turn off gas supply at cylinder valve.
8. Turn on control knobs to release gas pressure in hose.
9. Turn control knobs to "OFF" position.
10. Tighten any leaking connections. If leak is detected at connection nut and tightening does not stop leak, re-inspect propane tank
rubber seal.
11. Repeat soapy water test until no leaks are detected.
12. Turn off gas supply at cylinder valve until you are ready to use your grill.
13. Wash off soapy residue with cold water and towel dry.
14. Wait 5 minutes to allow all gas to evacuate the area before lighting grill.
WARNING: DO NOT use the grill if leaks cannot be stopped. Contact a qualified gas appliance repair service.
• Storage of an outdoor cooking gas appliance indoors is permissible only if the cylinder is disconnected and removed from the
outdoor cooking gas appliance.
• Cylinders must not be stored in a building or enclosure, including garages and sheds.
• Cylinders must be kept out of reach of children. Do not move the appliance during use.

DISCONNECTING A GAS CYLINDER

1. Ensure the regulator valve on the grill is completely closed by turning the knob clockwise to the OFF position.
2. Turn the cylinder counter-clockwise (by hand) to disconnect from the regulator valve opening. Replace the protective caps on the
regulator valve opening and the top of the gas cylinder for storage (if not empty).
NOTE: If storing the grill indoors, leave the gas cylinder outdoors.
WARNING: Do not fold up or transport grill with gas cylinder attached. The cylinder may loosen off the valve
and cause a gas leak, possibly resulting in an explosion, fire, or severe bodily harm. Disconnect gas cylinder first
before travel or storage.
Never light your gas grill with the lid closed or before checking to ensure the burner tubes are fully seated over the gas valve orifices.
Electrical equipment provided with the outdoor cooking gas appliance shall have the following in the instructions:
a. To protect against electric shock, do not immerse cord or plugs in water or other liquid;
b. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts;
c. Do not operate any outdoor cooking gas appliance with a damaged cord, plug, or after the appliance malfunctions or has been
damaged in any matter. Contact the manufacturer to repair;
d. Do not let the cord hang over the edge of a table or touch hot surfaces;
e. Do not use an outdoor cooking gas appliance for purposed other than intended;
f. When connecting, first connect plug to the outdoor cooking gas appliance then plug appliance into the outlet;
g. Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance;
8
• The full length of gas supply hose
• Hose connection to gas manifold
• Side burner connection to hose if appropriate
• Side burner valve stem cap if appropriate
• Gas supply hose connection
Watch for bubbles