Electrical Wire Diagram - Navigator PIT BOSS PB1230G Handbuch

The Digital Control Board system is an intricate and valuable piece of technology. For protection from power surges and electrical
shorts, consult the wire diagram below to ensure your power source is sufficient for the operation of the unit.
PB – ELECTRIC REQUIREMENTS
220-240V, 50HZ, 250W, 3-PRONG GROUNDED PLUG
NOTE: Electrical components, passed by product safety testing and certification services, comply
with a testing tolerance of ± 5-10 percent.
FUEL INPUT
GROUNDED
POWER CORD
RATING:
VW-1, 105°C/221°F,
2 KG/H
18-3 STANDARD CSA
(4.4 LB/H)
FIRE POT
INDEX
W : WHITE
Y : YELLOW
P : PURPLE
R : RED
K : BLACK
G : GREEN

ELECTRICAL WIRE DIAGRAM

LOCATE AND REMOVE
THE TWO SCREWS
OF ACCESS PANEL ON
THE SIDE OF HOPPER.
RELEASE BOTTOM
HOPPER PANEL DOWN
AND SLIDE BACK TO
UNSEAT FROM TAB.
K K
W W
G
GROUND
W
P
W W
W
W
IGNITER ASSEMBLY /
HD CARTRIDGE HEATER
200W, 230V,
0.375" X 5.000"
K
TEMPERATURE PROBE
MOLEX CONNECTOR
FAST-BLOW FUSE
5 AMP
P Y
P Y
R
W W
R R
AUGER MOTOR
& FEED SYSTEM
30 W, 230V,
2 RPM MOTOR
GRILL
PROBE
CONTROL BOARD
Y
Y Y
DRAFT FAN
50/60HZ, 230V,
1 PHASE
23