Before You Start; Inserting The Rechargeable/Conventional Batteries; Charging The Batteries; Preparing The Charging Cradle - Silvercrest SPMR 8000 B1 Bedienungsanleitung

8. Before you start

8.1. Inserting the rechargeable/conventional batteries

 If necessary, remove the belt clip (see the chapter "Removing the Belt Clip").
 Press the ribbed area of the battery compartment cover and slide it downwards. Then lift the battery
compartment cover upwards.
 Insert two AAA-sized batteries/rechargeable batteries into the battery compartment by respecting the
correct polarity. Note the + and – icons on the batteries and inside the battery compartment.
 Close the battery compartment. Insert the battery compartment cover into the corresponding notch on
the radio transceiver housing and then slide the battery compartment cover upwards until it clicks into
place.
 Replace the belt clip (see "Installing the belt clip").

8.2. Charging the batteries

If you use rechargeable batteries to power your SilverCrest SPMR 8000 B1 handheld radio transceiver
set, read this chapter carefully.

8.2.1. Preparing the charging cradle

 Place the charging cradle on a stable, flat surface.
 Plug the power adapter plug into the power receptacle [27] of the charging cradle.
 Plug the power adapter into a wall outlet.
(The figure is representational)
SilverCrest SPMR 8000 B1
English - 43