Bosch UniversalInspect Originalbetriebsanleitung Seite 22

22 | English
To switch off the inspection camera, press and hold the on/off button (4) for more than
3 seconds.
If no button on the inspection camera is pressed for approx. 20 minutes, then the in-
spection camera will automatically switch itself off to preserve battery life.
Photo mode
After being switched on, the inspection camera is in photo mode (13).
To switch from gallery mode to photo mode (13), press the (2) button. Pressing the
(2) button again actuates the shutter release.
A maximum of 8 images can be saved to the inspection camera's local memory. Every
further image that is taken deletes the oldest image in the local memory.
If more than 8 images are to be saved, a micro SD card (4 GB–32 GB) must be inserted
into the slot (18). When a micro SD card in FAT32 format is inserted, all images are auto-
matically transferred from the local memory to the micro SD card and deleted from the
local memory. All further images are saved on the micro SD card.
All images are automatically saved in the "Bosch" folder.
Note: All images are saved in their original state, i.e. without magnification or rotation.
Note: If an image was taken with black and white contrast, it cannot be called up in col-
our.
Gallery mode
Pressing the (1) button opens gallery mode (14).
The (6) and (5) buttons can be used to scroll backwards or forwards through the images
you have taken.
Briefly pressing the on/off button (4) shows the (h) and (i) symbols on the display.
Pressing the (5) button deletes the image. Pressing the (6) button stops the deletion
process. Briefly pressing the on/off button (4) reactivates gallery mode (14).
Pressing the (1) or (2) button switches to photo mode (13).
Status bar
The status bar (b) is shown on the display for approx. 3 seconds each time a button is
pressed. It shows:
– Photo mode (a) (brightness/black and white contrast) or gallery mode (e)
– The selected magnification (c)
– The state of charge of the batteries (d)
Setting the Brightness and the Black and White Contrast in the Camera Head
Switching the camera on also switches on the illumination light (11) in the camera head.
The set brightness is 50 %.
1 609 92A 69V | (26.01.2021) Bosch Power Tools